- 22
- Jan
It is not allowed to put the head close to the processing name to inspect the situation of the knife on the processing day
It is not allowed to put the head close to the processing name to inspect the situation of the knife on the processing day
Amikor a bárányszeletelő gép replaces the cutter bar, cutter head, end milling head, and milling cutter, it should be shut down first. After opening the power switch and loosening the tie rod screws, pay attention to prevent personal injury or tool damage. When the tool is running, it is not allowed to measure the size, match the template or touch the machined surface by hand. It is not allowed to put the head close to the processing name to inspect the situation of the knife on the processing day. When removing the work piece, be sure to move the cutting tool and continue. When disassembling the end mill, the table must be backed with stone slabs. Check that it is not allowed to support the cutter head by hand. When installing a flat milling cutter and using a wrench to pull the screw nut.