When choosing a good mutton slicer, you need to pay attention to the following issues

1. The inspection hole cover of the mutton slicer is too thin. Advantages of CNC mutton slicer After tightening the bolts, it is easy to deform, making the joint surface uneven and leaking oil from the contact gap.

2. There is no oil return groove on the valve body. Lubricating oil accumulates on shaft seals, end caps and mating surfaces. Under differential pressure, it leaks out of the gap.

3. Too much oil: During the operation of the CNC mutton slicer, the oil pool is very agitated. Oil splattered all over the machine. If the amount of oil is too large, a large amount of lubricating oil will accumulate on the shaft seal, joint surface, etc., causing leakage.

4. The structural design of the shaft seal is unreasonable. Most of the early CNC mutton slicers used oil sump and felt ring shaft seal structure. During assembly, the felt is compressed and deformed, and the joint surface gap is sealed.

5. Improper maintenance process: during equipment maintenance, improper cleaning of surface dirt, improper selection of sealants, timely replacement of seals, and timely replacement of seals will cause oil leakage.

In addition, there is a very important point, that is, in the process of processing, if the CNC mutton slicer is not annealed or aged, the internal stress will not be eliminated, deformation is inevitable, gaps will be generated, and leakage will occur. Therefore, it is recommended that you purchase equipment from regular manufacturers.