Common problems and corresponding solutions of vipande vya nyama ya ng’ombe na kondoo

1. The slicer does not move smoothly. At this time, lubricating oil can be added to the moving shaft of the slicer. If the ambient temperature is lower than 0 °C, low temperature resistant oil should be injected; at the same time, the moving square axis of the slicer should be properly adjusted. top screw at the bottom.

2. If there is vibration or slight noise in the working process of the slicer, first check whether its worktable is stable and whether the machine is placed flat; then check whether the machine bolts are loose, check whether the lubricating oil in the moving part of the machine is used up, and check whether the blades are loose. Wait.

3. When the slicer is working, the machine is powerless, which may be caused by the aging phenomenon of its capacitance. Therefore, check the capacitance of the slicer and repair it in time according to the actual situation, so that the slicer can return to the normal and stable working process.