Before boiling the lamb, we choose a good fresh lamb slicing machine

A good-quality beef and mutton slicing machine is also very user-friendly in the design of every detail. It can survive daily operations without damaging the machine. It has high slicing efficiency and good stability. In recent years, it has appeared on the market. Some highly imitation beef and mutton slicing machines, we call it the copycat version of beef and mutton slicing machines, this kind of slicing machine is close to the real product in appearance and other details cannot withstand the test, so remind consumers and friends to buy Beef and mutton slicing machine, you must look at the qualification of the other party, see if there is related patent certificate, etc., don’t try to be cheap, buy the fake beef and mutton slicing machine, those unreasonable designs will make you crazy

①The inspection hole cover of the beef and mutton slicer is too thin, and it is easy to deform after tightening the bolts, making the joint surface uneven and leaking oil from the contact gap;

②There is no oil return groove on the body, the lubricating oil accumulates in the shaft seal, end cover, joint surface, etc., and leaks from the gap under the action of the pressure difference;

③Too much oil: When the beef and mutton slicer is in operation, the oil sump is greatly agitated, and the lubricating oil splashes everywhere in the machine. If the amount of oil is too much, a large amount of lubricating oil will accumulate on the shaft seal, joint surface, etc. , Resulting in leakage;

④The shaft seal structure design is unreasonable. Early beef and mutton slicers mostly used oil groove and felt ring type shaft seal structure, which caused the felt to be compressed and deformed during assembly, and the joint surface gap was sealed;

⑤Improper maintenance process: During equipment maintenance, due to incomplete removal of dirt on the joint surface, improper selection of sealant, reverse installation of the seal, and failure to replace the seal in time, oil leakage may also occur.

Before we choose a slicer, we should pay attention to the five points mentioned above. If there are any of the above phenomena, please don’t buy it. When purchasing, we must go to a regular manufacturer to prevent buying products of poor quality.