Before boiling the lamb, we choose a good fresh lamb slicing machine

A good-quality beef and нарязване на овнешко месо machine is also very user-friendly in the design of every detail. It can survive daily operations without damaging the machine. It has high slicing efficiency and good stability. In recent years, it has appeared on the market. Some highly imitation beef and mutton slicing machines, we call it the copycat version of beef and mutton slicing machines, this kind of slicing machine is close to the real product in appearance and other details cannot withstand the test, so remind consumers and friends to buy Beef and mutton slicing machine, you must look at the qualification of the other party, see if there is related patent certificate, etc., don’t try to be cheap, buy the fake beef and mutton slicing machine, those unreasonable designs will make you crazy

①Капакът на инспекционния отвор на резачката за говеждо и овнешко месо е твърде тънък и лесно се деформира след затягане на болтовете, което прави повърхността на фугата неравна и изтича масло от контактната междина;

②There is no oil return groove on the body, the lubricating oil accumulates in the shaft seal, end cover, joint surface, etc., and leaks from the gap under the action of the pressure difference;

③Too much oil: When the beef and mutton slicer is in operation, the oil sump is greatly agitated, and the lubricating oil splashes everywhere in the machine. If the amount of oil is too much, a large amount of lubricating oil will accumulate on the shaft seal, joint surface, etc. , Resulting in leakage;

④ Дизайнът на структурата на уплътнението на вала е неразумен. Ранните резачки за говеждо и овнешко месо са използвали предимно маслен канал и структура на уплътнението на вала от филцов пръстен, което е причинило компресията и деформацията на филца по време на сглобяването, а междинната повърхност на ставата е била запечатана;

⑤Improper maintenance process: During equipment maintenance, due to incomplete removal of dirt on the joint surface, improper selection of sealant, reverse installation of the seal, and failure to replace the seal in time, oil leakage may also occur.

Before we choose a slicer, we should pay attention to the five points mentioned above. If there are any of the above phenomena, please don’t buy it. When purchasing, we must go to a regular manufacturer to prevent buying products of poor quality.