Hoe om te gaan met die skielike ontkoppeling van gevriesde vleis snyer

1. First, cut off the loose steel wire where the wire of the frozen meat slicer is broken, and leave two steel wire heads that are 10 cm longer than the distance between the guide wheels.

2. Gebruik growwe skuurpapier om die deursnee van die twee punte van die staaldraad tot die helfte tot twee derdes van die oorspronklike staaldraad te skuur, en die lengte moet groter as 5 cm wees. Gebruik fyn skuurpapier om die oppervlak van die staaldraad glad te maak, en gebruik dan alkohol om die oppervlak van die staaldraad glad te maak. Was die twee staaldraadpunte skoon.

3. The two steel wire ends with sand removed 5 cm are overlapped and welded together. In this process, one end of the heavy steel wire is used to weld a steel wire. The two steel wire ends must be completely overlapped so that the steel wire cannot be lifted. Then use fine sandpaper to smooth the welding place of the mutton slicer and the frozen meat slicer, and then wash it with alcohol.

1. The steel wire should have a long and loose section, and the loose section should be run to the guide rail. The welding head completely runs out of the guide pulley, and the length of a wire from the end of the guide pulley is divided by the groove distance of the guide pulley and multiplied by the length of one circle of the steel wire guide pulley.