Hur man hanterar den plötsliga urkopplingen av fryst köttskärare

1. First, cut off the loose steel wire where the wire of the frozen meat slicer is broken, and leave two steel wire heads that are 10 cm longer than the distance between the guide wheels.

2. Använd grovt sandpapper för att slipa diametern på ståltrådens två ändar till hälften till två tredjedelar av den ursprungliga ståltråden, och längden bör vara större än 5 cm. Använd fint sandpapper för att jämna ut ståltrådens yta och använd sedan alkohol för att jämna ut ståltrådens yta. Tvätta de två ståltrådsändarna rena.

3. The two steel wire ends with sand removed 5 cm are overlapped and welded together. In this process, one end of the heavy steel wire is used to weld a steel wire. The two steel wire ends must be completely overlapped so that the steel wire cannot be lifted. Then use fine sandpaper to smooth the welding place of the mutton slicer and the frozen meat slicer, and then wash it with alcohol.

1. The steel wire should have a long and loose section, and the loose section should be run to the guide rail. The welding head completely runs out of the guide pulley, and the length of a wire from the end of the guide pulley is divided by the groove distance of the guide pulley and multiplied by the length of one circle of the steel wire guide pulley.