Hoe om te gaan met de plotselinge ontkoppeling van? bevroren vlees snijmachine

1. First, cut off the loose steel wire where the wire of the frozen meat slicer is broken, and leave two steel wire heads that are 10 cm longer than the distance between the guide wheels.

2. Gebruik grof schuurpapier om de diameter van de twee uiteinden van de staaldraad te schuren tot de helft tot tweederde van de originele staaldraad, en de lengte moet groter zijn dan 5 cm. Gebruik fijn schuurpapier om het oppervlak van de staaldraad glad te maken en gebruik vervolgens alcohol om het oppervlak van de staaldraad glad te maken. Was de twee uiteinden van de staaldraad schoon.

3. The two steel wire ends with sand removed 5 cm are overlapped and welded together. In this process, one end of the heavy steel wire is used to weld a steel wire. The two steel wire ends must be completely overlapped so that the steel wire cannot be lifted. Then use fine sandpaper to smooth the welding place of the mutton slicer and the frozen meat slicer, and then wash it with alcohol.

1. The steel wire should have a long and loose section, and the loose section should be run to the guide rail. The welding head completely runs out of the guide pulley, and the length of a wire from the end of the guide pulley is divided by the groove distance of the guide pulley and multiplied by the length of one circle of the steel wire guide pulley.