Fenomena yang harus dihindari dalam mendesain alat pengiris daging sapi dan kambing

1. During the design process, the thickness of the inspection hole cover plate configured for the beef and mutton slicer is insufficient, so that it is easy to deform after the bolt is tightened, resulting in an uneven joint surface and oil leakage from the contact gap .

2. Tidak ada alur balik oli pada bodi, sehingga mudah menyebabkan oli pelumas berkumpul di segel poros, penutup ujung, permukaan sambungan, dan posisi lainnya. Di bawah aksi perbedaan tekanan, itu akan bocor keluar dari beberapa celah.

3. Too much lubricating oil is added. In this case, when the beef and mutton slicer is in normal operation, the oil sump will be greatly agitated, causing the lubricating oil to splash everywhere in the machine. And if the amount of oil is particularly large, it will also cause leakage.

4. Desain struktur segel poros tidak masuk akal. Misalnya, struktur segel poros jenis alur oli dan cincin kempa sebagian besar digunakan sebelumnya. Dengan cara ini, masalah deformasi kompresi juga rentan terjadi selama proses perakitan.

5. The maintenance method is unreasonable. When the beef and mutton slicer has some abnormal conditions, we need to carry out the maintenance in time. And if there are problems such as incomplete removal of dirt on the joint surface, improper selection of sealant, or reverse installation of the seal, it is likely to cause oil leakage.