Përse prerëse viçi dhe deleje appear to fly

The phenomenon of flying pieces is easy to occur when the cutting of thin slices and wafers are finished to the graphite pallet. This is because the friction force of the blade on the wafer is too large and the graphite pallet cannot bear it, causing the product to be taken away by the blade.

From the actual operation, we found that when the cutting fluid drips from the cutting edge of the cutting wafer, it will easily take off. This is because the cutting fluid flow is too large, which increases the friction and causes the phenomenon of flying fins. . Therefore, the flow of cutting fluid should not be too large, and the flow of cooling and lubrication at the cutting edge during cutting can be satisfied.