Me ya sa slicer of beef and mutton have flying pieces?

The phenomenon of flying flakes means that it is easy to occur when the slicing and wafer slicing ends to the graphite pallet. This is because the friction force of the blade on the wafer is too large and the graphite pallet cannot bear it, resulting in the phenomenon that the wafer is taken away by the blade.

It can be seen from the above analysis that there is cutting fluid between the blade of the slitter blade and the wafer, and the blade has a frictional force on the wafer. The size of the frictional force is proportional to the cutting area and the flow rate of the cutting fluid, so reduce the flow rate of the cutting fluid. The method can solve the phenomenon of flying flakes.

From the actual operation, we found that when the cutting edge of the cutting wafer has cutting droplets, the phenomenon of flying pieces will easily appear. This is because the flow of cutting fluid is too large, which increases the friction and causes the phenomenon of flying pieces. . Therefore, the flow rate of cutting fluid should not be too large, and the flow rate of cooling and lubrication at the cutting edge can be satisfied.